Table of Contents
Advertisement
Obtain Video Signal
The camera can simultaneously have HD-SDI, IP video output and CVBS.
SDI Video Signal
The camera can simultaneously stream SDI video output with DVI video output.
1. Connect SDI cable in between the camera your SDI Device/display.
2. You now have SDI video output.
CVBS Video Signal
1. Connect CVBS cable in between the camera with Extension Cable plugged in and your CVBS Device/display.
2. You now have CVBS video output.
IP Video Signal
1. For obtaining IP video signal guidance refer to this user manual Part-Two.
Camera Initial setting status Information
Information of the camera initial setting status will display for 5
seconds.
1. Camera physical ID for RS-422/485 control
2. Camera ID for IR Remote Controller
3. IR remote control signal receive current setting
4. Baud Rate current setting
5. Control COMM Port current setting
6. Video format current setting
7. HDMI current setting
8. Model number
9. Firmware version
PELCO
IR
IR-RECEIVE:
BAUD RATE:
COMM TYPE:
FORMAT:
HDMI OUT:
MODEL TYPE:
SV: V0A0100A020401A01
10
ID:
001
ID:
01
ON
9600
232
1080P30
YUV
------
Advertisement
Table of Contents
