Power Up The Camera Using Hdbaset Receiver; Ideo Signal; Control The Camera Using Hdbaset Receiver - Bolin Technology BC-7 Series User Manual

Power up the camera using HDBaseT receiver

Bolin HDBaset receiver uses 54V DC 2.77Amp power adaptor to provide power to the HDbaseT unit. The
HDBaseT receiver unit provides power to the camera via CAT6 cable, the power standard is compatible
with POH(Power-Over-HDBaseT), POE(IEEE802.3af/at/bt) which is up to 97W.
Use HDBaseT Receiver to obtain HDMI 4K / HD Video signal
1. Use Cat 6 network cable to connect the camera to HDBaseT Receiver.
2. Connect HDBaseT Receiver to a 4K or HD monitor/TV using HDMI cable. For displaying 4K video, a
HDMI version 1.4 needs to be used.
3. Power on the HDBaseT Receiver, the camera will be powered on by the receiver, video will display on
the monitor after running initializing.
4. Information of the camera initial setting status will display for 5 seconds.
5. You can set the video format of the camera to the one you want to display.

Control the camera using HDBaseT Receiver

Using HDBaseT you can have following methods of controlling to the camera.
1. Use the Infrared Remote Controller
2. Use RS-232 (VISCA)
3. Use RS-422/485 (VISCA/PELCO P/D)
4. Use HDBaseT Receiver to control.
NOTE:
In order to use HDBaseT method of controlling, must set the camera in RS232 control
method on Dip Switch.
25