Obtain Signal; Video Signal; Audio In / Out - Bolin Technology BC-7-M-12262019 User Manual

Conductor:
AWG Stranding
18 Solid
Shield Material
Type Layer
Tape 1
Braid 2
Nom. Capacitance
Conductor to shield
16.2 pF/ft

Obtain Signal

The camera can simultaneously have SDI video output and HDMI video output and IP video output.

Video Signal

HDMI HD Video signal
1. Connect the camera to a HD monitor/TV using HDMI cable.
2. Turn on the camera, video will display on the monitor after running initializing.
3. Information of the camera initial setting status will display for 5 seconds.
4. You can set the video format of the camera to the one you want to display.
SDI Video Signal
The camera can simultaneously stream SDI video output with HDMI video output.
1. Connect SDI cable in between the camera your SDI Device/display.
2. You now have SDI video output.
3. SDI video only supports 1080P.
IP Video Signal
The camera can simultaneously stream IP video output and SDI video output and HDMI video output.
1. Connect the camera to the network using Cat5/Cat6 network cable.
2. You need to have a web browser or VMS client software ready for IP video streaming.
3. PELCO address and Baud Rate setting on the camera must be as same as the setting on camera IP WEB
interface.
4. To obtain IP video and configure IP video, please refer to Network Camera User Manual Part Two.
CVBS Video Signal
1. Connect CVBS cable in between the camera and your CVBS
Device/display.
2. You now have CVBS video output.

Audio IN / OUT


A microphone can be connected to the Audio IN port, which feeds
audio into the camera

A speaker can be connected to the Audio OUT port, which will output
any audio that is captured on the Audio In port

See Manual part 2 for more information about Audio capture
Material Nominal Diameter
Bare Copper 0.04 in.
Material
Aluminum / Polyester / Aluminum 100%
Tinned Copper
Nom. Inductance
0.106 µ H/ft
Coverage
95%
Nom. Char. Impedance
75 Ohm
14