Table of Contents
Advertisement
Conductor:
AWG
Stranding
18
Solid
Shield Material
Type
Layer
Tape
1
Braid
2
Nom. Capacitance
Conductor to shield
16.2 pF/ft
Obtain Video Signal
The camera can simultaneously have SDI video output and HDMI video output and IP video output.
HDMI HD Video signal
1. Connect the camera to a HD monitor/TV using HDMI cable.
2. Turn on the camera, video will display on the monitor after running initializing.
3. Information of the camera initial setting status will display for 5 seconds.
4. You can set the video format of the camera to the one you want to display.
SDI Video Signal
The camera can simultaneously stream SDI video output with HDMI video output.
1. Connect SDI cable in between the camera your SDI Device/display.
2. You now have SDI video output.
3. SDI video only supports 1080P.
CVBS Video Signal
1. Connect CVBS cable in between the camera and your CVBS Device/display.
2. You now have CVBS video output.
Camera Initial setting status Information
Information of the camera initial setting status will display for 5 seconds.
1. Camera PELCO ID for RS-485 control
2. Camera ID for IR Remote Controller
3. IR remote control signal receive current setting
4. Baud Rate current setting
5. Control COMM Port current setting
6. Video format current setting
7. HDMI current setting
8. Model number
9. Firmware version
Material
Nominal Diameter
Bare Copper
0.04 in.
Material
Aluminum / Polyester / Aluminum
Tinned Copper
Nom. Inductance
0.106 µ H/ft
Coverage
100%
95%
Nom. Char. Impedance
75 Ohm
Camera Status Info Display
PELCO ID
IR ID
IR-RECEIVE
BAUD RATE
COMM TYPE
FORMAT
HDMI OUT
MODEL TYPE
SV:
11
001
01
ON
9600
232
1080P29.97
RGB
----
V0B010B10040AA002
Advertisement
Table of Contents
