BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual page 53

RIDING THE VEHICLE
Crossing Water
Water can be a unique hazard. If it is too deep the vehicle may "float" and topple.
Check the water depth and current before you attempt to cross any water. Water
should not go above the footrest. Be wary of slippery surfaces such as rocks,
grass, logs, etc., both in the water and on its banks. A loss of traction may occur.
Do not attempt to enter the water at high speed. The water will act as a brake and
could throw you off the vehicle, on the ground.
sfvmo2014-012-524
Wet brakes will affect the braking ability of your vehicle. Make sure you dry the
brakes by applying them several times after the vehicle leaves the water, mud or
snow. Allow greater distance for braking.
Mud or marsh lands may be encountered near water. Be prepared for sudden
"holes" or changes in depth. Similarly so, be watchful of hazards such as rocks,
logs, etc., partially covered by vegetation.
Riding on Ice
If your route crosses frozen waterways, make sure the ice is thick enough and
sound enough to support the total weight of yourself, the vehicle and its load. Be
ever watchful of open water it is a sure indication that the ice thickness will vary.
Ice will also affect the control of the vehicle. Slow down and do not "gun" the
throttle. This will only result in spinning of the tires and possible tip over of the
vehicle. Avoid rapid braking. This again will possibly result in an uncontrolled slide
and tip over of the vehicle. Slush should be avoided at all times since it could block
the operation or controls of the vehicle.
Riding on Snow Covered Surfaces
When performing the pre-ride inspection, pay special attention to locations on the
vehicle where snow and/or ice accumulations may obstruct visibility of the taillight
and reflectors, clog ventilation openings, block the radiator and fan, and interfere
with the movement of control levers, switches and brake pedal. Before starting
with your ATV check the steering, throttle and brake lever and pedal controls for
interference free operation.
________ ________
SAFETY INFORMATION 51