Machine Details Menu - Loma IQ2 Service Manual

MACHINE DETAILS MENU

The following list details the individual menu positions sitting below the "Machine
details menu" and their use.
Machine details
* Machine
Software fitted
Epr chksum
There are no further menu positions in this section.
Module 7026
" " " "
[
Press ] to access the menu options following.
This menu position allows you to enter the serial number of the detector
found on the serial number label located inside the control cabinet. Or a
line identification name or number. Information is entered in the same
manner as for "Product name".
The software version fitted to your detector is displayed.
Note: The Software version fitted to your detector control board will also
be displayed for approximately 0.5 seconds each time the detector is
switched on.
The computed checksum for your fitted software is displayed
Configuration and Set up Information
5-24