Menu Definitions - Loma IQ2 Service Manual

MENU DEFINITIONS

User options
Tracker
The following explanation applies only to software version 1.4 and below.
Enables two working thresholds to be set. The working threshold selection is automatic
and is used for frozen product that is subject to slight thawing effects.
(V1.4 & below)
The following explanation applies only to software version 1.5 and above.
Tracker is now trend-based system that allows the working threshold to go up or down
between two predetermined limits. Thus following small changes in the product effect
from frozen product that is subject to slight thawing effects. This allows the sensitivity
of the detector to be optimised for situations where the product signal drifts up and
down. Product Signal Tracking
the Definitions section of this chapter.
Reject time
Please refer to the Installation and Guide to Commissioning section of this manual for
details on the use of this feature.
Manual setup
Turning this on allows the user to make manual adjustments to the calibration of the
unit via the Manual setup menu.
Auxiliary relay (Aux relay)
The relay marked Attention on the power relay PCB has two different functions: select
Run, in order that the relay is energised whenever the detector is in run, i.e. it is
looking for metal; select ERROR, in order that the relay is energised when a run error
occurs.
Access Ferrite
Turning this on allows the user to gain access to product F, either via the Change
Product or Product setup menus. For more information, please refer to the Installation
and Guide to Commissioning Section of this manual on performing a ferrite tune for
minimum vibration.
Module 7026
information is listed in the Definitions section of this chapter.
on page 36
on page 37
Configuration and Set up Information
set up (V1.5 & above) information is listed in
Tracking limit
5-34