Loma IQ2 Service Manual page 30

Tracker:
Reject time:
Manual setup:
Aux relay:
Access ferrite: This entry must be set to YES, in order that a ferrite tune can
Rej out of run: Set to YES or NO as required. Normally left at NO.
Cal trigger:
Dual frequency: Only used on rectangular/square conveyor heads. Set to YES
Aux relay:
*PV test:
*Fault on PV:
*Reverse mode: Set to YES or NO as required. YES will cause the detector to
Exit the User Options menu by pressing the [
Module 7026
Turning this facility on allows the user to select the tracker
option for each of the products as required. See
for more information about the benefits of the tracker
page 34
facility, and how it can be used. This option is only available if
a photo eye is fitted.
Leave this at the default option of ON to enable access to the
reject timing information in the Product Setup menu. Only set
this to OFF once the reject time has been correctly set, and
you wish to prevent line operators access to it.
Turn this ON or OFF as required.
Change this to ERROR or RUN as required. This determines
the whether the Attention relay operates on RUN or ERROR.
be performed - see step six.
Turn this ON or OFF as required. (Used with pipeline when
pipeline option in configuration is selected).
when the detector is built as a dual frequency. Setting to YES
automatically fixes the function of the Auxiliary relay to DUAL.
Normally left at the default setting of IN RUN. However it can
be set to REJECT to operate as a third set of reject relay
contacts.
Set to YES or NO as required. YES will enable the
Performance Validation System.
Set to YES or NO as required. YES will cause the fault relay to
operate if a Performance Validation System test is not done or
completed in the time allowed.
reject when there is no metal present in the product. NO is
normal operation. The menu entry will only appear if Photo eye
in the configuration menu is set to YES.
Configuration and Set up Information
C
] key once.
Tracker
on
5-8