Loma IQ2 Service Manual page 50

Serial link menu configuration
The serial link menu protocol for link 1 is configured as follows:
Link 1 may be set to one of the following options. Press
then again and use the [
USAGE
LOMALINK
or
REPORTS
" " " "
[
Press ] to accept.
When LomaLink or Reports is selected further menu entries within the link allow the
protocol to be set.
[!
Press the ] key to step down the menu below.
* Baud rate
* Data bits
* Stop bits
* Parity
* Flow Ctrl
" " " "
[
Pressing the
keys to select entry required then press
Pressing the [C] Key will exit the menu without making any changes.
NOTES
Please refer to the Displaying and printing reports in your user manual if using the
report option, or appropriate LomaView, LomaNet or LomaLink information.
Module 7026
!
] to select one of the uses below.
- "NOT USED" is the default setting
- For use with LomaLink control protocol.
- For use with LomaView management systems.
- For use with LomaNet or a single printer.
- 150, 300, 600, 1200, 2400, 4800, 9600
- 7 or 8
- 1, 1.5 OR 2
- ODD, EVEN or NO
- NONE, CTS-RTS or XON-XOFF
] key in any menu position changes the "
Configuration and Set up Information
" " " "
[
" to a ">", use the "
*
" " " "
[
] key again to accept.
] to select the usage list
[$ [!
] ]"
5-28