Safety Measures; Intended Use Of The Machine - Loma X5c Operating Instructions Manual

14

Safety Measures

Before attempting to use the system, carry out the following basic checks to ensure that it is
in a safe condition and ready to be used:-
 Check that the electrical power, and air supply if being used, are connected
correctly and are working normally.
 Check that the conveyors are clean and clear of any products or other items.
 Check that all panels, inspection hatches and the Electrical Cabinet are closed and
locked.
 Check the area in front of the system to ensure that it is clean and clear of any
potential trip or slip hazards.
 Check the control panel to ensure that the system is working correctly and no
warning or error messages are being displayed.
In addition, the following points should be observed for safe operation of the system:-
 Installation, commissioning, operation and maintenance of the system should only be
carried out by Loma trained personnel, following the applicable safety measures.
 Any attempts at servicing and/or repair of the system by unqualified personnel may
result in damage which could result in the introduction of a safety hazard and the loss
of warranty cover.
 Care should be taken when carrying out tasks in areas of the system that are
potentially hazardous; as identified with an appropriate
 Removal of any guards, covers and other protective devices must only be carried out
by authorized or qualified personnel after first switching off and removing any power
from the system.
 For the protection of operating personnel, safety switches are installed in easily
accessible places on the system, all of which trigger an EMERGENCY STOP.
 All safety devices must be functional at all times! Damaged protective devices or
covers must be repaired or replaced immediately! When safety components are
replaced, the protective devices are to be properly attached and tested by the
operator.
If you require spares or service / repair of your machine, please send an email to
enquiries@loma.com.

Intended Use of the Machine

Permitted Use
The Loma X X-Ray Inspection System is used in the food industry to; inspect products for the
5c
inclusion of contaminants, non-conformance, to set product integrity parameters, weigh
packaged products and automatically remove contaminated and under/overweight
products from the production line, stop the line, alert the operator or a combination of these.
The system is automated so generally does not need an operator present. Operator
intervention is generally required to change the product or the system settings which is
performed standing in front of the system using the touchscreen.
Document Number: 814212-2.0-ENG
Safety First
safety label.
Original Document