Epson S1D13503 Series Technical Manual page 83

AUX
Data
Register
(in Binary)
AUX[0Fh] 0000 1011 write Green data
AUX[0Fh] 0000 1001 write Blue data
AUX[0Eh] 0000 1100 increment palette address
AUX[0Fh] 0000 0110 write Red data
AUX[0Fh] 0000 0110 write Green data
AUX[0Fh] 0000 1101 write Blue data
AUX[0Eh] 0000 1101 increment palette address
AUX[0Fh] 0000 0100 write Red data
AUX[0Fh] 0000 0100 write Green data
AUX[0Fh] 0000 1001 write Blue data
AUX[0Eh] 0000 1110 increment palette address
AUX[0Fh] 0000 0010 write Red data
AUX[0Fh] 0000 0010 write Green data
AUX[0Fh] 0000 0100 write Blue data
AUX[0Eh] 0000 1111 select palette address
AUX[0Fh] 0000 0000 write Red data
AUX[0Fh] 0000 0000 write Green data
AUX[0Fh] 0000 0010 write Blue data
AUX[01h] 1101 0101 program Mode Register bit DISP to 1, and set LCDE to enable
Note: A
Line Byte Count
B Single Panel
C Dual Panel
Total Display Line Count
2. Write one pixel to the top left corner of the display's second panel.
If the S5U13503P00C evaluation board is used in indexed mode, there are two video memory
banks which begin at D000:0000 (2 banks × 64K per bank; see the note on page 5). If the base
port address is 310h, then read from port address 312h. Next, write 0C0h to location
D000:9600h; this will be seen as a white pixel at the top left corner of the display's second panel.
S18A-G-002-02
power supply
1001 0000b 'OR' {original value for AUX[01h]}
• b7 = display on (application specific)
• b4 = LCDE = LCDENB pin = set to enable specific power
supply design (for S5U13503P00C, set bit to 1 to enable
power supply) (application specific)

Bits Per Pixel
= -------------------------------------------------------------- - Horizontal Resolution

Memory Interface Width
 
2
×
= ----- - 640 –
 
16
Total Display Line Count
Number of Display Lines
= ---------------------------------------------------------------- - 1
S1D13503 Programming Notes and Examples
Notes
×
1 = 79 = 4Fh
= Number of Display Lines 1
480
= --------- - 1
–
2
See Also

1
–

–
= 239 = 0EFh
–
2
2-7