Epson S1D13503 Series Technical Manual page 160

EPSON
Program Messages
ERROR: 13503 registers not responding at port address [port].
13503READ has not found an S1D13503 at the port address specified. Check the command line port
setting for 13503BIOS and/or 13503READ to ensure it is correct and re-run the program.
ERROR: 13503READ requires a port address.
13503READ has not detected 13503BIOS.COM to obtain the port address and no port address was
specified on the command line. Either specify a port address on the 13503READ command line or
run 13503BIOS.COM prior to running 13503READ.
ERROR: 13503BIOS reports a port address of [port], which is different from the specified
port address of [port].
The port address entered for 13503READ is different than the one entered for 13503BIOS.COM.
Specify the same port address on the 13503READ command line as the one in 13503BIOS.COM
and the physical address of the S5U13503P00C evaluation board and re-run the program.
WARNING: 13503BIOS state is out of sync with S1D13503 registers.
One or more of the following command line items reported by 13503BIOS does not match the val-
ues found in the S1D13503 registers; horizontal panel size, vertical panel size, number of colors/
gray shades, or panel type (single or dual).
3-12 S18A-B-006-01