Mounting In The Beam Tower; Installation Example At Particular Case - Optex Smart Line Series Installation Instructions Manual

2-8 MOUNTING IN THE BEAM TOWER

1 In accordance with the type of the main unit inside the beam tower, install the detector in the same way as wall mounting or pole mounting.
< Mounting with the chassis >
Make function settings and optical alignment before mounting the cover.
2
When installing the detector without the cover, hold the tamper button with the tamper lock plate on both the transmitter and receiver.
Tamper lock plate
Loosen the screw.
1
Caution

2-9 INSTALLATION EXAMPLE AT PARTICULAR CASE

1
If possible, avoid installing the transmitter and receiver facing
each other in a slanting direction as shown below.
[ Top view ]
Transmitter
Tamper button
2
The switch selection is not recognized when locking the tamper button.
Release the tamper button before selecting a function using the switch.
After completing the settings, be sure to lock the tamper button to check that all LEDs are
OFF. If the tamper button is not locked, the LEDs are kept ON, which consumes more
battery power.
Monitor jack output become disabled when locking the tamper button.
If you do not close the tamper lock plate, the sensitivity will be reduced as adjustment
mode will not end. Be sure to close the tamper with the tamper lock plate.
Receiver
< Mounting without the chassis >
Rotate the tamper lock plate.
2
In case you do this installation, the maximum detection range
shall be half of the original detection range. (This is to prevent
the attenuation of beam by the edge of the cover.)
e.g.) SL-200QDM: 60m/200ft.
-9-
3
Fasten the screw to lock
the tamper button.
30m/100ft.