Mounting In The Beam Tower - Optex AX-100TFR Installation Instructions Manual

Fix the chassis on the pole.
4
Detector 2
U-bracket
M4×30 screw
(supplied) (supplied)
After mounting the chassis, wiggle the tamper bushing
with your thumb and forefinger to ensure the tamper
works properly.
Refer to sec. "3-1" steps 3 through 6 to install the wireless
5
transmitters and batteries in the back box, and then install the
back box on the chassis.
Tighten the
back box lock screw.
Detector 1
M4×30 screw
(supplied)
Caution

3-3 MOUNTING IN THE BEAM TOWER

Mounting inside optional beam tower.
Remove the cover from the detector.
1
Loosen the main unit fixing screw and remove the main unit
2
from the back box.
Loosen the
main unit fixing screw.
Cables are connected between the back box and the
main unit. Do not exert an excessive amount of force
on the cables. Handle the main unit with care.
Remove the harness retainer plate.
3
Harness retainer
plate (sticker)
Open the wiring hole in the top of the main unit using pliers.
4
Remove the chassis from the back box.
5
-5-
Caution
Main unit
Wiring hole
Loosen the
back box lock screw.