Alarm Management
Exception Alarm Handling Configuration:
Click Start→Settings→Alarm→Intelligence Alarm→Exception to go to the interface.
①
Enable or disable "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The
②
alarm handling setting of exception detection alarm is similar to that of the sensor alarm (see
for details).
Click "Apply" to save the settings. You can click "Exception Config" to go to the exception detection
③
configuration interface.
9.3.3 Tripwire
Line Crossing Configuration:
Alarms will be triggered if someone or something crosses the pre-defined alarm line.
Click Start→Settings→Camera→Intelligent Analytics→Tripwire to go to the following interface.
①
Select the camera, enable the line crossing detection.
②
Select the direction.
③
Direction: A<->B, A->B and A<-B optional. It is the crossing direction of the intruder who crosses over the
alert line.
A<->B: the alarm triggers when the intruder crosses over the alert line from B to A or from A to B.
A->B: the alarm triggers when the intruder crosses over the alert line from A to B.
A<-B: the alarm triggers when the intruder crosses over the alert line from B to A.
Draw line. Refer to the interface as shown above. Check "Draw line" and then drag the mouse in the
④
image to draw an alert line. Uncheck the "Draw line" if you finish the drawing. Click the "Clear" to delete the
alert line.
Click "Apply" to save the settings.
⑤
Click "Processing Mode" to go to the alarm handling configuration interface of line crossing detection.
⑥
Tripwire Alarm Handling Configuration:
Click Start→Settings→Alarm→Intelligence Alarm→Tripwire to go to the following interface.
①
57
DVR User Manual
9.1 Sensor Alarm