Speco H6HRN User Manual page 36

PTZ
➢ OSD Setting
Go to PTZ protocol setting interface and then set the protocol before you bring up the OSD. Click "OSD
Menu" to go to camera OSD setting interface. Click
are shown in the table below.
➢ Preset Setting
Click "Preset" to go to preset operation tab and then click "Add" button to pop up a window as shown below.
Select the preset and then enter the preset name in the window; finally click "OK" button to save the settings.
You can add 255 presets for each dome at most.
Adjust the dome's direction and then click "Save Position" to save the current preset position (you can also
click another preset in the preset list and then save the preset position after adjusting the dome's direction);
click in the preset list to call the preset; click "Delete" button to delete the selected preset.
You can also go to preset setting interface for preset setting, see
➢ Cruise Setting
Button Meaning
Click it to call main menu or enter the sub menu or confirm the
settings.
Click it to call main menu or enter the sub menu or confirm the
settings.
Click it to change the menu mode or decrease the menu value.
Click it to change the menu mode or increase the menu value.
Click it to go to the previous menu.
Click it to go to the next menu.
to start OSD setting. The meanings of the buttons
6.2 Preset Setting
30
DVR User Manual
for details.