Live View Introduction
4.1 Camera Signal
Click Start→Settings→Camera→Manage Camera→Camera Signal to go to the interface as shown below.
Some models may support analog signal switching to IP signal, which means decreasing (or increasing) the
number of analog channels will accordingly increase (or decrease) the number of IP channels.
The DVR device supports hybrid access of TVI, and CVBS high definition cameras. If the TVI high definition
camera is accessed to the DVR, you should select TVI/CVBS in the following interface to show the camera
image normally; if you select AHD/CVBS, then there will be no image or the image has no color. The default
selection of the camera signal is Auto. If you select Auto, the image of the camera will be shown normally
regardless of the camera type.
Note: You can enable "Lite" in the interface if the DVR supports "Lite" recording. It will lower the recording
resolution and increase the recording frame rate. Please enable or disable the Lite as needed.
4.2 Add/Edit Camera
4.2.1 Add Camera
The network of the DVR should be set before adding IP camera (see
Refer to the pictures below. Click Add Camera in the setup panel or
preview window to pop up the "Add Camera" window as shown below. You can quickly add or add the IP
camera manually.
4 Camera Management
16
for details).
12.1.1 TCP/IP Configuration
in the top right corner of the
DVR User Manual