Table of Contents
Advertisement
Remote Surveillance
12.1 Mobile Client Surveillance
Enable NAT in the DVR. Refer to
①
Scan the QR Code through the Speco Blue App available for iOS and Android to easily and securely view
②
your cameras.
Run the mobile client, go to the "Add Device" interface and then click
③
(Go to Start→Settings→System→Information→Basic to view the QR Code of the DVR).
After scanning the QR Code successfully, enter the login password to log in mobile client.
④
12.2 Web LAN Access
Click Start→Settings→Network→TCP/IP to go to the "TCP/IP" interface. Set the IP address, subnet mask,
①
gateway, preferred DNS and alternate DNS of the DVR.
Open the web browser on your computer, enter the IP address of the DVR in the address bar and then
②
press enter to go to the login interface as shown below. You can change the display language on the top
right corner of the login interface. Enter the username and password of the DVR in the interface and then
click "Login" to go to the live view interface.
Notes: 1. Please make sure that the IP address of the DVR and the computer are both in the same local network segment. For example, supposing that the IP
address of the computer is 192.168.1.41, the IP address of the DVR shall be set to 192.168.1.XXX.
2. If the HTTP port of the DVR is not 80, but other number instead, you need to input the IP address plus port number in the IE address bar when
accessing the DVR over network. For example, the HTTP port is 81. You should enter http://192.168.1.42:81 in the IE address bar.
12.3 Web WAN Access
Set the network of the DVR. Please refer to
①
12 Remote Surveillance
for details.
11.1.8 NAT Configuration
11.1.1 TCP/IP Configuration
78
to scan the QR Code of the DVR
for details.
DVR User Manual
Advertisement
Table of Contents
