Table of Contents
Advertisement
Live View Introduction
DVR User Manual
mode. Double click the sequence view interface to pause the view; double click again to restore the view.
Click
to stop the view.
5.2.3 Scheme View In Sequence
Click Start→Settings→System→Basic→Output Settings to go to the interface as shown below.
Area ① displays all the sequence schemes; area ② shows the detailed information of the scheme; area ③
displays all the cameras and groups; area ④ is the tool bar (
: clear button;
: favorite button, click it to
pop up a window, enter the display mode name in the window and then click "OK" to save the current
display mode; other buttons are screen mode buttons).
➢ Add Scheme
Click
in area ① to create a new scheme. Click
on the top right corner of the scheme to delete it.
➢ Configure Scheme
a) Select a scheme in area ① and then click the screen mode button on the tool bar to set the screen mode of the scheme.
b) Select a camera window in area ② and then double click the camera or group in area ③. The camera or group will be added into the
selected window. One camera in the same scheme cannot repeat. You can click the right-click menu "Clear" in area ② to remove a single
camera or click
to remove all the cameras.
c) Click "Apply" to save the settings.
➢ Start Sequence View
22
Advertisement
Table of Contents
