Recorder Osd Settings; Factory Default; Device Software Upgrade - Speco H6HRN User Manual

Device Management

11.2.3 Recorder OSD Settings

Click Start→Settings→System→Basic→Recorder OSD settings to go to the following interface. Name, icon
and address OSD can be enabled here.

11.3 Factory Default

Click Start→Settings→System→Maintenance→Factory Default and then click "Restore factory setting"
button in the interface to reset to the factory default settings (check "all except the network" to retain the
network settings). Click "Restore default parameter" to restore the parameters to the default status (check
"all except the network" to retain the network settings).
Note: Resetting to the factory default settings will not change time zone.

11.4 Device Software Upgrade

⚫ Upgrade
You can click Start→Settings→System→Information→Basic to view MCU, kernel version and firmware
version and so on. Before upgrade, please get the upgrade file from your dealer.
The upgrade steps are as follows:
Copy the upgrade software into the USB storage device.
①
Insert the USB storage device into the USB interface of the DVR.
②
75
DVR User Manual