Camera Group View In Sequence; Scheme View In Sequence - Speco N64NR24TB User Manual

Live View
Introduction
click to view the live group by group according to the camera number of the current screen mode. Double click the
sequence view interface to pause the view; double click again to restore the view. Click

5.2.3 Camera Group View In Sequence

You can start camera group view in sequence if camera group has been created (see
details).
1 Go to the live view interface and then select a camera window.
2 Double click one camera group on the right side of the interface. The cameras in the group will start camera group
view one by one in the selected camera window.
You can also drag the group directly to any preview window. Right click on the group view window and then click
"Close Dwell" button to stop the view.
You can also add camera group in the live view interface. Select "Single Channel Sequences" and then click
add camera group. Click

5.2.4 Scheme View In Sequence

Click StartSettingsSystemBasicOutput Settings to go to the interface as shown below.
Area ① displays all the dwell schemes; area ② shows the detailed information of the scheme; area ③ displays all the
cameras and groups; area ④ is the tool bar (
display mode name in the window and then click "OK" to save the current display mode; other buttons are screen
mode buttons).
to modify the group name and sequence interval. Click
: clear button; : favorite button, click it to pop up a window, enter the
26
NVR User Manual
to stop the view.
4.2.1 Add Camera Group
to delete the group.
for
to