Lenovo 10A4 Hardware Maintenance Manual page 213

Figure 185. Removing the front fan assembly
7. Install the new front fan assembly by aligning the four new rubber mounts on the new front fan assembly
with the corresponding holes in the chassis and push the rubber mounts through the holes. Pull the tip
of each rubber mount from the outer side of the front panel until all rubber mounts go through the holes
and secure the front fan assembly in place.
Figure 186. Installing the front fan assembly
8. Connect the cable of the new front fan assembly to the power fan connector on the system board. See
"Locating parts on the system board" on page 81.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 224.
Chapter 9
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
205