Lenovo 10A4 Hardware Maintenance Manual page 209

Figure 178. Pivoting the drive bay assembly upward
5. Locate the secondary hard disk drive bay. See "Locating major FRUs and CRUs" on page 79.
6. Disconnect the signal cable and the power cable from the primary hard disk drive and secondary hard
disk drive.
7. Pull the blue handle to slide the secondary hard disk drive out of the carrier.
Figure 179. Removing the secondary hard disk drive
8. To install a new hard disk drive into the blue bracket, flex the bracket and align pin
pin 4 on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit board
5 on the bottom of the hard disk drive.
Chapter 9
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
1 , pin 2 , pin 3 , and
201