Lenovo 10A4 Hardware Maintenance Manual page 144

Figure 81. Removing the thermal sensor
7. Pull the entire thermal sensor out of the chassis.
8. Insert the connector and cable of the new thermal sensor into the lower hole
the two tabs on the plastic holder holding the thermal sensor with the two holes
and push the plastic holder until it snaps into position.
Figure 82. Installing the new thermal sensor
9. Reconnect the thermal sensor cable to the system board. See "Locating parts on the system board" on
page 73.
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 92.
136
ThinkCentre M83 and M93/p Hardware Maintenance Manual
1 in the chassis. Then align
1 and 2 in the chassis,