Lenovo 10A4 Hardware Maintenance Manual page 205

Figure 171. Pivoting the drive bay assembly upward
5. Remove the cable clip on the bottom of the primary hard disk drive bay as shown.
Figure 172. Removing the cable clip
6. Align the four holes in the secondary hard disk drive carrier with the corresponding four tabs on the
bottom of the primary hard disk drive bay as shown. Then, position the carrier onto the bottom of the
primary hard disk drive bay so that the tabs on the bay pass through the holes in the carrier.
Chapter 9
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
197