Lenovo 10A4 Hardware Maintenance Manual page 169

2. Remove the computer cover. See "Removing the computer cover" on page 153.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 154
4. Locate the optical drive bay. See "Locating major FRUs and CRUs" on page 79.
5. Press the retaining clip
same time.
Figure 112. Pivoting the drive bay assembly upward
6. Disconnect the signal cable and the power cable from the rear of the optical drive.
7. Press the optical drive lock
of the rear of the bay.
Figure 113. Removing the optical drive
8. Remove the optical drive retainer from the side of the old optical drive and install it on the side of the
new optical drive.
Chapter 9
1
in the direction as shown and pivot the drive bay assembly upward at the
1 on the right side of the drive bay assembly and slide the optical drive out
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
161