Figure 175. Installing the screw to secure the secondary hard disk drive carrier
9. Flex the sides of the blue bracket to remove the primary hard disk drive from the bracket.
10. To install a new hard disk drive into the blue bracket, flex the bracket and align pin
pin
4
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit board
5
on the bottom of the hard disk drive.
Figure 176. Installing the hard disk drive into the bracket
11. Slide the new secondary hard disk drive into the carrier until it snaps into position.
Chapter 9
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
1
, pin
2
, pin
3
, and
199