Lenovo 10A4 Hardware Maintenance Manual page 211

1. Install the solid-state drive into the adapter. Then, install the four screws to secure the solid-state drive
to the adapter.
Figure 182. Installing the solid-state drive into the adapter
2. To install the adapter with a solid-state drive into the blue bracket, flex the bracket and align pin
2 , pin 3 , and pin 4
board 5 on the bottom of the solid-state drive.
Figure 183. Installing the adapter with a solid-state drive into the bracket
3. Install the solid-state drive assembly into the hard disk drive bay. See "Replacing the primary hard disk
drive" on page 194.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 224.
Chapter 9
on the bracket with the corresponding holes in the adapter. Do not touch the circuit
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
1 , pin
203