Installing The Solid-State Drive - Lenovo 10A4 Hardware Maintenance Manual

Figure 69. Installing the secondary hard disk drive
9. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 150.

Installing the solid-state drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
1. Install the solid-state drive into the storage converter. Then, install the four screws to secure the solid-
state drive to the storage converter.
126
ThinkCentre M83 and M93/p Hardware Maintenance Manual