Figure 120. Pivoting the drive bay assembly upward
5. Disconnect the card reader cable from the system board.
6. Remove the screw that secures the card reader assembly. Push the card reader assembly to the right
and then remove it from the chassis.
Figure 121. Removing the card reader assembly
7. Install the new card reader assembly into the card reader drive bay until it snaps into position. Then,
push the new card reader assembly to the left until the screw hole in the metal bracket of the card reader
assembly is aligned with the corresponding hole in the chassis.
Chapter 9
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
165