13
13.1
Creating slot in the cover for the drive shaft
13.2
Fitting and removing the cover
1004935-US-1.0
The cover and mounting plate are manufactured in clear anodized aluminum.
1. Measure the distance X on the mounted operator from the pivot end of the back
plate to the center line of the output shaft.
2. Use a 1" (25 mm) hole saw to cut the round hole for the output shaft.
3. Use a hack saw to make two straight cuts.
The cover is slid over flanges in the back plate so that the ridges fit in the
grooves. Secure with screw.
Stick the Besam logotype to the cover – see below.
2
1
1. Top end plates for cover
2. Bottom end plate
Issue 2008-11-13
L C
X
1"
5 6
3 4
1 2
ON
1 2 3 4
5 6 7 8
3
4
3. Earth/Fastening screw
4. Besam logotype
Cover
ILL-02016
9 10
7 8
ILL-01557
"
1
39