Cover - Assa Abloy besam SW100 Installation And Service Manual

14
14.1 Creating slot in the cover for the drive shaft
14.2 Fitting and removing the cover
1003680-US-4.0
The cover and back plate are manufactured in clear anodized aluminum. The end
plates are made of black painted steel sheet.
1. Measure the distance X on the mounted operator from the pivot end of the back
plate to the center line of the output shaft.
2. Use a 1" (25 mm) hole saw to cut the round hole for the output shaft.
hack
3. Use a saw to make two straight cuts.
The cover is slid over flanges in the back plate so that the ridges fit in the grooves.
Snap on the fill cover into the slot for output shaft. Secure cover with screws.
Stick the Besam logotype to the cover – see below.
Stick the label to the underside of the cover – see below.
Issue 2007-10-11
L C
= Output shaft, center line
X
1"
Disconnect from
supply before
servicing

Cover

Cover
5/8
"
43