Table of Contents
Advertisement
5.
Perform a brief battery test to verify that the Power+ Premium is ready and able to operate in battery
mode when needed. To perform a battery test, from the main menu choose:
"Operation > Battery test > Test battery". After 1 minute, cancel the test by pressing
"Abort the test > OK".
6.
Verify that the ac output circuit breakers on the electrical board are OFF.
You can now connect a load device to the ac output, then turn ON the ac output circuit breakers on the
electrical board.
7.
Now you must update the last maintenance date. From the main menu, choose
"Setup > Time > Set last maintenance date". Click on the line that says "Last maintenance date".
Press "confirm", and enter the system password if prompted for it.
8.
Finally, to save the settings you have defined, from the main menu choose:
"Setup > Save and restore > Save settings > OK".
2.6.2
Define the IP Address of Power+ Premium
This procedure assigns an IP address to the Power+ Premium. Assigning an IP address enables you, the
user, to remotely monitor and control the Power+ Premium over an IP network. If you do not intend to
remotely monitor the Power+ Premium this step can be skipped. If you decide later to implement remote
monitoring, you can perform this process at that time.
The Power+ Premium supports use of a fixed IP address, and also supports dynamic assignment of IP
addresses (DHCP). Consult your IT systems administrator and determine if your IP network supports
DHCP, and if there is a preference for using either a fixed IP address or a dynamically assigned IP address
for the Power+ Premium.
To obtain an IP address automatically (your network must support DHCP):
1.
From the Main Menu select Setup > Connectivity.
2.
Press the button labeled "Obtain an IP address automatically".
The Power+ Premium software obtains an IP address and then reboots itself.
To assign an IP address manually:
1.
Press the button labeled "Use static IP address".
The IP definition screen is displayed
Power + PREMIUM, Installation Guide, rel. 1.7
G
E
AMATRONIC
LECTRONIC
Figure 25: IP address configuration
I
L
.
NDUSTRIES
TD
25
Advertisement
Table of Contents
