Table of Contents
Advertisement
2.3
Installation procedure
After completing each step in the following installation, go back to the Installation Checklist and check the
corresponding item.
2.3.1
Visual inspection
Perform the following inspection immediately after unpacking the Power+.
1.
Inspect the Power+ from all sides and ensure that there is no visible damage to any portion of the
housings or covers. If any damage is found, contact your distributor immedately.
2.
Ascertain that the number of housings and modules delivered is as ordered, and that a system
controller module was delivered.
3.
Verify that a LCD touch screen was delivered.
4.
Ensure that all components and modules are complete and securely fastened to their shelves.
2.3.2
Site preparation – physical
Perform the following procedures before connecting any external cables to Power+.
1.
Ensure that the ambient temperature in the immediate vicinity of Power+ complies with Gamatronic
requirements.
Minimum / maximum operating temperatures: -10 °C / +40 °C (+14 °F / +104 °F).
Recommended temperature: +15 °C ~ +25 °C (+59 °F ~ +77 °F).
2.
Verify that there is no water condensation or dampness at the installation site.
3.
Ensure that sufficient airflow or forced ventilation is present at the location of the battery cabinets.
4.
Verify that the foundation and access routes are adequate for the dimensions and weight of the UPS
and battery cabinets.
5.
Ensure that there are adequate clearances to allow comfortable access to battery cabinets and
electrical boards. Ensure that there is 36 in. (91 cm) clearance at the rear for cable connections and
39 in. (100 cm) at front for user access and service.
Figure 3: Ensure sufficient free space at front and rear of the UPS
Power + PREMIUM, Installation Guide, rel. 1.7
G
E
I
AMATRONIC
LECTRONIC
NDUSTRIES
L
.
TD
5
Advertisement
Table of Contents
