Table of Contents
Advertisement
Figure 20: Initial config. wizard: number of battery cabinets or battery compartments
5.
Indicate the total capacity of all connected battery cabinets, in ampere/hours (Ah), then press "Next".
(This capacity figure is used by the UPS when in battery mode to calculate the amount of backup
time remaining.)
If you are not sure of your battery cabinet's Ah capacity, look at one of the batteries in the cabinet.
The Ah rating is usually indicated on the battery's exterior. The Ah rating of a single battery is the
same as for the entire cabinet. Enter this number in the wizard screen.
22
G
AMATRONIC
Figure 21: Initial config. wizard: set battery capacity
E
I
L
LECTRONIC
NDUSTRIES
TD
Power + PREMIUM, Installation Guide, rel. 1.7
.
Advertisement
Table of Contents
