Oce sx1481 User Manual page 93

Item
Start Service
Setting
Agent
Identification
Security
Initialize
3
Configure the settings.
4
When you are finished, click [Save] to save the settings.
If you want to quit without saving, click [Close].
Description
Set the SNMP agent service to enable or disable.
"Contact Destination"
Enter the administrator name.
Up to 255 characters can be entered.
"Name"
Enter the machine model name.
Up to 40 characters can be entered.
"Location"
Enter the location where the machine is installed.
Up to 100 characters can be entered.
"Name" and "Location" fields are shared with "Device Setting"
in "Management Information" column. This means if you
change these fields, the fields in Device Setting will also be
changed, and vice versa.
Enter the community name.
The community name is used to check whether incoming
SNMP requests have the correct community name or not. The
community name is displayed as ••••• for security reasons.
The default community name is "public".
You can enter up to 20 characters for the community name.
For details, refer to the documentation of the SNMP manager
you are using.
If you want to specify the hosts from which to accept the SNMP
request, check "Accept requests from specified hosts" and enter
the IP address and community name.
Up to three hosts can be registered.
Initialize the SNMP settings. The settings will return to the
factory default setting.
The "Name" and "Location" will not be initialized. To initialize
them, click [Device Settings] from "Management Information"
column, then click [Initialize].
6-13