Chap. 12 Reset To Defaults; Resetting To Factory Defaults - Pima FORCE Installation Manual

Force Security System - Installation Guide

Chap. 12 Reset to Defaults

Reset to Defaults
The
1)  Select Parameters: select the parameters to be reset, from the following list:
Communication

Zones

Outputs

User

Full System Reset - includes all the above.

2)  Reset to Defaults: press to reset the selected parameters.
Warning: this action cannot be undone!
12.1

Resetting to factory defaults

If the Master technician code is unavailable, the FORCE can be reset to its factory defaults.
To reset to the factory defaults, do the following:
1. Disconnect the alarm system from AC and battery power for 5 seconds.
2. Reconnect AC power.
3. Within 30 seconds from when the main screen is displayed, press 000000 (six zeros). The
system reset screen is displayed.
Press and Wait
4. Press on
5. When the reset process is over, set new Master codes. See section 3.2, on page 23 for
details.
6. Reconnect the battery.
44
menu includes the following sub-menus:
.