Add-On Installation And How To Replace The Sim Card - Pima FORCE Installation Manual

Force Security System - Installation Guide
Antenna Base
SIM Card
Holder
Figure 19. Add-on's front side
2.13.3

Add-on installation and how to replace the SIM card

Disconnect AC and battery power before connecting the add-on.
1. Insert the SIM card to the SIM holder: hold the SIM card so that the metal contacts are
facing down, and the notch is aligned correctly, as shown in Figure 19, above.
2. Connect the antenna to the add-on, by rotating its connector clockwise, and place the
antenna where the cellular network signal is strong. The antenna's cable is 3 meters long.
3. Pressing gently, connect the add-on to the socket (J8).
4. Reconnect the control panel to power and set the add-on in the
Modules/GSM Module
5. Test the add-on
22
Network
Modem Power
Registration
Figure 21. The GSM add-on installed onboard
menu (see page 37).
Onboard
Connector
Figure 20. Add-on's back side
GSM501
Peripherals/Comm.
Onboard
Socket