Pima Cloud; General Setting; Telephone Settings - Pima FORCE Installation Manual

Force Security System - Installation Guide
Event
Low temp
High Humidity
Low Humidity
Low water pressure
Low water level
8.2

PIMA Cloud


System Configuration
Select the communication path to the cloud. The options are Network (Ethernet) and GPRS-IP.
See section 8.1.1 above for details.
8.3

General Setting


System Configuration
Parameter
 Remote Up/
Download
 Remote Disarm Select to enable remote system disarm via the PIMAlink app.
8.4

Telephone Settings


System Configuration
Parameter
 Telephone
Connected
External Line
Access
Prefix
Rings to Answer
 Check Dial
Tone
 Answering
Machine
 VoIP
 Line Check at
Arm
36
ContactID SIA
159 ZA
168 -
169 -
201 WT
204 WT
CMS & Communications
CMS & Communications
Details
 Selected: remote upload/download via the FORCE Command software
without the need for user permission is enabled.
 Not selected: remote upload/download is enabled only with user
permission (see the User guide [P/N 4410460] for how to details)
CMS & Communications
Details
Select if the control panel is connected to PSTN line.
Set an access number (up to seven digits) for private PBX.
Set digit/s to be dialed before any of the PSTN telephone numbers.
Set the number of rings before the control panel answers a call.
 Selected: dial tone will be checked before making a call
 Not selected: the control panel will dial without checking for dial tone
Answering or facsimile machine are connected to the telephone line. To
connect to the control panel by phone remotely, do the following:
1) Call the FORCE.
2) Wait for 2 rings.
3) Hang off.
4) Wait a few seconds and redial.
The telephone line uses Voice over IP technology.
When the alarm system is armed away dial tone will be checked every 1
minute.

PIMA Cloud

General Setting

Telephone Settings