Chap. 5 Peripherals; Zone Expanders; Tampers And Eols - Pima FORCE Installation Manual

Force Security System - Installation Guide
Chap. 5
Peripherals
The menu includes the following sub-menus:
1)  Zone Expanders: see below.
2)  Tampers & EOLs: see below.
3) Keypads: set the no. of addressable keypads (ID 1-16). Keypad with ID no. 0 is not
supervised, nor can it be partitioned.
4) Keypads: see section 5.3, on page 27.
5) Output Expanders: set the no. of the relay output expanders.
5.1

Zone expanders


System Configuration
Zone Expanders
The
1) Remote Expanders: set the no. of 8/16 remote zone expanders.
Each 16-zone expander is programmed as two 8-zone expanders and occupies 2
consecutive ID numbers. For example, if expander #3 is a 16-zone one, it takes
ID numbers 3 and 4 and so expander #4, the next expander will take ID number
5 (and not 4).
2)  Local Zone Expander: select if the ZEL508 local zone expander is installed.
3)  Zone Doubling: when selected the onboard zone 1-8 inputs can be used as inputs for 8
additional zones; see section 2.6.1, on page 11.
5.2

Tampers and EOLs


System Configuration
Parameter
 Tamper 1
 Tamper 1+EOL
 Tamper 2
 Tamper 2+EOL
 External Siren+EOL
 Internal Siren+EOL
 Double EOL
Resistor 1-2
26
Peripherals

Peripherals Zone Expanders
menu includes the following sub-menus:

Peripherals Tampers and EOLs
Description
TMPR1 input is active.
TMPR1 input is EOL supervised, for detecting a short.
TMPR2 input is active.
TMPR2 input is EOL supervised, for detecting a short.
SIREN Ext. output is EOL supervised, for detecting cut and short.
SIREN Int. output is EOL supervised, for detecting cut and short.
Two EOL resistors are used on ALL EOL supervised zone loops.
Enter the resistors values in Ohm. The value entered is multiplied by
100. For example, when using a 2.2 k resistor, set the value to
220
.