Connect The Klt/Klr500 Keypads - Pima FORCE Installation Manual

Force Security System - Installation Guide
Action and alarm keys
Pressing and holding some keys allows the following actions:
Key Action
1-4 Arming to Home 1-4 modes
5 Display zone status
* Turn on/off the keypad's buzzer for all the chime zones
0 Display the service provider, system name and cloud code
Keypad alarms
The users can trigger three different alarms - panic, fire, and medical - by pressing and holding
key combinations on the keypad. When these alarms are triggered, FORCE activates the
programmed responses for such alarms, including triggering the sirens and reporting the CMS
(where relevant) and contacts.
Key Alarm
Combination
4 + 6 Medical
7 + 9 Fire
* + # Panic
Keypad settings
Press and hold the keypad settings key
screen. In this screen you set the keypad's audio visual definitions:
contrast brightness
, ,
Each setting is scaled 0-9. Settings are per keypad.
Use the arrow keys to select a parameter, press Esc
and exit.
Warning: if you set the volume to 0, no alert will be sounded from the
keypad buzzer, including from chime zones.
2.12.3

Connect the KLT/KLR500 keypads

Follow the next steps to connect the keypads
1. Insert a flathead screwdriver to the notches on the keypad's
bottom, press and remove the backplate.
2. Pass the BUS wires through the opening at the backplate.
3. Mount the backplate on a flat surface.
4. Connect the BUS wires.
5. Attach the keypad to the mounted backplate, top side first.
5 The tamper reports over the BUS.
20
Response
The same as in
The same as in
The same as in
keys backlight
and the buzzer's
Medical
zone
Fire
zone
Panic
zone
to enter the settings
volume
.
to save
5 :