Fastening The Module With Profile Adapter On Profile Rail; Replacing The Labeling Fields - Bosch Rexroth IndraControl S67 Manual

DOK-CONTRL-S67DIO4M12H-AP02-EN-P
Rexroth IndraControl S67 Digital Module High Speed 4 Inputs/Outputs – 0.2 A (84×M12)
5.6.2

Fastening the Module with Profile Adapter on Profile Rail

5.7

Replacing the Labeling Fields

To fasten the S67-DIO4-HS-M12 module to a profile rail of the system, two
nuts are required with one screw each (length of screw threads must be com‐
patible with the system).
1. Disconnect the power supply from those devices on which you wish to
mount the S67-DIO4-HS-M12 module.
2. Insert the two screws into the holes above and beneath the fastened
S67-DIO4-HS-M12 module on the profile adapter.
3. Fasten an appropriate nut on each of these screws.
4. Insert the profile adapter with the attached S67-DIO4-HS-M12 module
into the profile rail of the system. Position the profile adapter and tighten
the screws.
The module labeling card and labeling strip are attached ex works. The pro‐
tective cover is to be removed when labeling the labeling strip. Proceed as
follows:
1. Press the slot screwdriver (maximum slot width: 3 mm) into the small
opening under the labeling strip cover (12) and lever the cover up.
2. Remove the labeling strip cover.
3. Label the labeling strip with a waterproof pen.
4. Reinsert the labeling strip cover and press the cover firmly in place.
If the module labeling card (10) is to be replaced, proceed in accordance with
the step sequence described previously. New module labeling cards are
available from Bosch Rexroth as accessories.
1 0
2
X
3
0
X
1
Fig. 5-5: Replacing the labeling fields
Bosch Rexroth AG
DIO4-HS
SB SB
F
3
12
X
4
1
X
2
24V 24V
U U U U
LS LS A A
31/79
Mounting the Module