Bosch Rexroth IndraControl S67 Manual page 42

40/79 Bosch Rexroth AG
Connecting Data and Supply Cable
Rexroth IndraControl S67 Digital Module High Speed 4 Inputs/Outputs – 0.2 A (84×M12)
NOTICE
Please note that the combined power consumption of all connected sensors/
actuators must not exceed 1 A. The distribution of power among the existing
connections is depending on the individual power requirements of the sen‐
sors.
To connect sensors/actuators to the digital inputs and outputs, proceed as
follows:
1. Disconnect the power supply from those devices on which you have
mounted the S67-DIO4-HS-M12 module.
2. Insert the plug of the sensor or actuator cable into the socket of a digital
input or output (3) of the S67-DIO4-HS-M12 module, and tighten the
plug using the knurled-head screw.
3. Screw a protective cap on all unused connections to comply with IP67
degree of protection.
3
Fig. 6-4: Digital input/outputs
DOK-CONTRL-S67DIO4M12H-AP02-EN-P
The sensor's/actuator's power consumption
must not exceed 1 A!
DIO4-HS
SB SB
F F
3
X
4
2
X
3
1
X
2
0
X
1
24V 24V
U U U U
LS LS A A
3