Status Indications According To Namur Recommendation - AUMA SA 07.2 Operation Instructions Manual

Indications
8.2.3.

Status indications according to NAMUR recommendation

50
SA 07.2 SA 16.2/SAR 07.2
Figure 58: Fault
For further information, please also refer to <Corrective action>.
These indications are available, if the parameter Diagnostic classific. M0539 is set
to NAMUR.
Out of Specification (S0008)
The S0008 indication shows out of specification indications according to NAMUR
recommendation NE 107.
If such an indication has occurred, the display shows S0008:
the number of indications occurred
a blinking triangle with question mark after approx. 3 seconds
Figure 59: Out of specification
For further information, please also refer to <Corrective action>.
Function check (S0009)
The S0009 indication shows function check indications according to NAMUR
recommendation NE 107.
If an indication has occurred via the function check, the display shows S0009:
the number of indications occurred
a blinking triangle with a spanner after approx. 3 seconds
Figure 60: Function check
For further information, please also refer to <Corrective action>.
Maintenance required (S0010)
The S0010 indication shows maintenance indications according to NAMUR
recommendation NE 107.
If such an indication has occurred, the display shows S0010:
the number of indications occurred
a blinking square with an oilcan after approx. 3 seconds
SAR 16.2 Control unit - electromechanical
AC 01.2 Intrusive Modbus RTU