AUMA SA 07.2 Operation Instructions Manual page 3

SA 07.2 SA 16.2/SAR 07.2
AC 01.2 Intrusive Modbus RTU
6.2.5. Fieldbus cables: connect
6.2.6. Fieldbus terminal compartment: close
6.3. Accessories for electrical connection
6.3.1. Actuator controls on wall bracket
6.3.2. Parking frame
6.3.3. DS intermediate frame for double sealing
6.3.4. External earth connection
7. Operation................................................................................................................................
7.1. Manual operation
7.1.1. Manual valve operation
7.2. Motor operation
7.2.1. Operating the actuator from local controls
7.2.2. Actuator operation from remote
7.3. Menu navigation via push buttons (for settings and indications)
7.3.1. Menu layout and navigation
7.4. User level, password
7.4.1. Password entry
7.4.2. Password change
7.4.3. Timeout for incorrect password entry
7.5. Language in the display
7.5.1. Language change
8. Indications..............................................................................................................................
8.1. Indications during commissioning
8.2. Indications in the display
8.2.1. Feedback signals from actuator and valve
8.2.2. Status indications according to AUMA classification
8.2.3. Status indications according to NAMUR recommendation
8.3. Indication lights of local controls
8.4. Optional indications
8.4.1. Mechanical position indication via indicator mark
9. Signals (output signals).........................................................................................................
9.1. Status signals via output contacts (digital outputs)
9.1.1. Assignment of outputs
9.1.2. Coding the outputs
9.2. Analogue signals (analogue outputs)
10. Commissioning (basic settings)...........................................................................................
10.1. Type of seating: set
10.2. Fieldbus address (slave address), baud rate, parity and monitoring time: set
10.3. Open switch compartment
10.4. Torque switching: set
10.5. Limit switching: set
10.5.1. End position CLOSED (black section): set
10.5.2. End position OPEN (white section): set
10.6. Intermediate positions: set
10.6.1. Running direction CLOSE (black section): set
10.6.2. Running direction OPEN (white section): set
10.7. Test run
10.7.1. Direction of rotation at mechanical position indicator: check
10.7.2. Direction of rotation at hollow shaft/stem: check
SAR 16.2 Control unit - electromechanical
Table of contents
33
34
35
35
36
36
37
38
38
38
39
39
40
40
41
42
43
43
44
44
44
46
46
46
47
49
50
51
52
52
53
53
53
53
53
54
54
55
55
56
57
57
57
58
58
59
59
59
60
3