Table of Contents
Advertisement
14. If prompted, configure the TCP/IP settings for the
Harmony 802.11b PC Card.
15. When prompted, select Yes, I want to restart my com-
puter now, and click <Finish>. Restart the computer.
The Harmony 802.11b PC Card should now be successfully
installed.
Confirming That the Card Has Been Successfully Installed
To confirm that the driver has loaded correctly, open the PC
Card icon in the Control Panel and view the properties for the
Harmony 802.11b PC Card. The Device Status should read:
"This device is working properly." Also, under the Driver tab,
the Driver Status should read: "The driver installed and started,"
or "The driver installed, started, and configured this device."
If the Driver Status states: "The driver installed but did not
start," or "The driver did not start," the card was not properly
installed. The Windows NT Event Viewer will also report that
an error has occurred if the card was not present or did not load
properly during boot-up.
If the Harmony 802.11b PC Card did not install properly, refer
to Chapter 6 for troubleshooting suggestions that may help you
solve the installation problem.
Installing Protocols
To determine what protocols are installed, open the Control
Panel's Network icon and select the Protocols tab.
You may add and configure protocols, such as TCP/IP, from this
screen.
30
Advertisement
Table of Contents
