Table of Contents
Advertisement
14) power supply connector
Manipulation of the programmed device
After selection of the device you wish to work with you can insert it into the open ZIF
socket (lever is up) and close the socket (lever is down). The correct orientation of the
device in the ZIF socket is shown on the diagram near the ZIF socket on the
programmers cover. The programmed device must only be removed from the socket
when the BUSY LED is not illuminated.
Note: The programmer's protection electronics protect the target device and the
programmer itself against either short or long-term power failures and partly against a
PC failure. However, it is not possible to guarantee the integrity of the target device due
to incorrect user-selected programming parameters. The target device may not be
destroyed by forced interruption of the control program (turning off the programmer), but
the contents of programmed cells may remain undefined. Don't remove the target
device from the ZIF socket during operations with device (BUSY LED on).
In-system serial programming DATAMAN-
848PRO2
Optimized advanced pindrivers deliver high programming performance without
overshoot or ground bounce for all device technologies. Pin drivers operate down to
1.8V so you'll be ready to program the full range of todays and tomorrow's advanced
low- voltage devices.
The ISP programming solution performs programming verification at the marginal levels
of supply voltage, which obviously improves programming yield and guarantees long
data retention.
The ISP programming solution can also provide the power supply for the target system.
This ISP programming solution provides very competitive price but excellent hardware
design for reliable programming.
The software provides full and detailed information for ISP implementation: Description
of ISP connector pins for the currently selected chip, recommended target design
around the in-circuit programmed chip and other relevant information.
7
Advertisement
Table of Contents
