Table of Contents
Advertisement
Sounds...
The Dialog Sounds settings allows the user to select the sound mode of the program.
The program generates sounds after certain events, e.g. activities on device
(programming, verifying, reading, etc.). The program generates sound also when
warning or an error message is displayed. The user can now select sounds from the MS
Windows system sounds (requires installed sound card), PC speaker or No sound.
The check box "Use beep sound on touch screen press" allows switching of the beep
sound on or off. When the checkbox is checked the beep sound will be generated on
each touch screen press, that the software detects. Otherwise no beep sound will be
generated.
Options / Statistics...
This command displays the dialog "Statistics". Statistics gives information about the
actual count of device operations which were processed on the selected type device. If
one device is corresponding to one device operation, e.g. programming, the number of
device operations will be equal to the number of programmed devices. The statistics
dialog contains the following options:
Check boxes: Program, Verify, Blank and Erase which define operations, after which
statistics values increment.
Any selected and performed device operation will increment the Total counter and one
of the Success or Failure counters depending on the device operation result (success
or failure).
A combination of partial operations is counted as one operation only. For example, a
Read operation including Verify after Read is one operation. A Program operation
including Erase and/or Verify operations is counted as one operation.
36
Advertisement
Table of Contents
