Table of Contents
Advertisement
• Program
• Erase
Each Master operation can consist of a sequence of one or more partial operations, for
example the Program device operation can consist of the following sub-operations:
1.Erase
Selection of the sub-operations is stored in the Project file. For details about project file
creation and usage, refer to the chapter on Engineering mode.
Preselected device operations can be started using the button Run <operation_name>
displayed on the main screen.
Menu Programmer
Programmer / Search for programmers...
This menu command displays the dialog "Search programmers", which is used to
reinitialize the software configuration and to re-find available programmer sites. There is
no need to use this menu command in normal operation. Situations,when the command
is useful are:
1. when first starting DATAMAN-848PRO2 Stand-Alone multiprogramming system
2. when the error message "Programmer Sites not found" is displayed
In the dialog "Search Programmers" use the button "Search" to search for attached
programmers. The result of the search will be displayed in the table Search results in
the Search dialog. When the programmers sites are successfully found, the result
shows the programmer type, and allows you to accept the new settings using the button
2.Program
3.Verify
29
Advertisement
Table of Contents
