Dataman -848PRO2 User Manual page 28

File / Switch to Engineering mode
This command is used to start the Pg4uw control program in Engineering mode. In this
mode the user can use the Pg4uw software to select any device from the list of
supported devices, set options for the device, load data files for device, test the device
operations on any programmer site and create a project file which can be used in
production mode. More information about Engineering mode is available in the chapter
Engineering mode.
To switch back to production mode just close the Pg4uw control program and run the
program Pg4uwMC by double-clicking on the Pg4uwMC icon on the Desktop.
Note:
Engineering mode requires connection of an external VGA monitor, keyboard and
mouse.
Do not use this menu option, without these peripherals connected and working.
File / Shut down computer
This command is used to close the control program and to shut down the built-in
computer. It is similar to the command "Shut down" found in Microsoft Windows
operating systems.
Menu Device
Device / Predefined operation
This menu allows the user to select the device Master operations. The following Master
operations are available:
• Blank check
• Verify
28